I can only say, this cross-cut saw is highly accurate for my needs. The angle adjustment has no significant deviation (gemesen with Bevel Box: less than one degree) so I did not even need to adjust further. The laser was with me even without deviation and also did not require adjustment (but is good that this can be adjusted). Even in a bright room, I could see the laser line clearly. For me, the cut was exactly next exactly on the line or laser. Festool solves the yes with 2 laser lines which are left and right of the blade. I find a red line is sufficient.
The sectional view (spruce) was very clean. Provided you do not sawed too fast. It was even possible for me, a thin blade to cut into the wood which was thin under a millimeter.
At the processing I do not see Patzer / slip.
The chip collecting funnel with a strong suction draws the most chips a, however, only the most. A small portion still bib.