Benefits:
- Easy
- Mounted quickly
- Very easy to install
- Small pack size
- With 30 cm² a large enough area
Disadvantages:
- Obstructing the air vents on flash head
Brief explanation on certain points:
Mounting takes place using an adhesion Velcro band and is done in seconds, even without exercise and without leaving traces to eliminate completely well again.
If you do not need the bouncer, he folds to approximately 20x25x1,5 cm. The extra weight is not noticeable in the camera case.
Of course, large studio Bouncer care with 0,5-1 m² for softer light, but do not you wear also so readily around with you. After my purely subjective impression that light is much softer than the small, milky plastic bouncers that exist for the flashes to. So it's a good compromise.
Now the only negative point (but only a few flash units is relevant and therefore nothing to change 5 stars): When installing the ventilation holes are covered on my Nissin MG8000 extreme. This latter is not as well cooled and should not be used in continuous operation (ie only as other top flashes can also).
Ceaseless continuous operation but also more likely to be found in the studio, and there you can also use other Bouncer with tripod, or one is content just yet with the milky plastic cap as a bouncer.
As I said, there is always a compromise and is here also especially considering the low price, really succeeded
