The unit is now for 2 months now and again in use and the conclusion is positive! After 15min unpacking (you can also overdo it with tape, film, packing material, etc.) like the touch screen with largely meaningful translations of menu items. As loud as feared, the device is not, the previous HP F4280 slammed against literally as it feeds. One quirk I have but already have experience and has cost some time to research and nerves: After initial use of 10x15 photo paper 6500A wanted the paper size no longer accept ("Incorrect format") and threw regularly correctly adjusted A4 sheet back out. Even when drivers was nothing else than set earlier, A4. In a global fabric, there are a few tips: - Firmware update, last comes from 15:04:11 -> did not help Issue paper type sensor via the menu -: -> is not at all - Reset (cartridges out, pull out the plug, wait 1min) - I did not even try. Actual cause was only on the US-HP-pages as a general error solution: paper alignment! So the menu item hidden under Setup | Extras ... Paper Align (or something similar) Choose - and suddenly the nightmare was over.
If HP better to install as an aid in the menu - or the prominent must show on the german pages.. Obviously the thick photo paper has the "seeing" printhead adjusted and stood still beside the paper ...
The nowadays must make sure that the print head approved the paper - not to believe ...