I bought this router about a year ago and had since then only a few times in use. At first I was very happy with it. Processing made a very reliable impression. But over time, there is a noticeable play in the guide columns has been felt that was getting worse. Meanwhile, this game is approximately 1-2 mm around the rotational axis, and 0.5mm grown in the horizontal. This makes it no longer possible to work exactly and precise repeatability when setting is excluded. I have it registered with the Service Hotline of Einhell, there I was told I could repair the defective parts yourself. Email me then the required spare parts. When I disassembled the cutter I have the evil found the same. The guide columns are performed only in an aluminum housing, without any permanent camp. with time, the aluminum has worn and the game has emerged. It looks difficult for me for a design flaw from occurring again even beyond repair within a short time. I strongly advise against purchasing this router !!! For me, it has the saying "who buys cheap buys twice" sometimes full bewarheitet again. I'm going to save up my money for a good, used brand router and not again make the mistake with such a cheap part.