Installation is a little complicated because you have to remove the backplate. Depending on the case you have to ensure the whole system disassemble, but that is to be absorbed. With its flat design, the fumbling with the clip would be considerably more complicated. Apropo: Due to the flat design, the cooler is certainly very good for HT PCs.
My big concern before buying was that no longer fit my large RAM module. Low profile requires the radiator but since only the first two slots. The third and fourth slot are completely free.
What is special about the radiator: it has two fans. A big top and a little in the middle. Both can attach in two positions, which makes the ventilation concept quite flexible. Unfortunately, only the big 4PIN a port, so you can not control with the same small. But I have the bypassed by I have connected a T-adapter to the fan and the controller have made with my Gigabyte board of PWM on Voltage. Now both are driven in parallel.
I can definitely recommend the fan as it cools down the motherboard. The only disadvantage is that you can use only low-profile memory in the first two RAM slots, but the other two are free. Otherwise great!