The outlet has approximately 50 km (easy connection via the power supply of the main headlight, then it draws in the state also no electricity) works. That was enough to try, then the cable trim (not convertible ...) and for the first few minutes on vacation. Then it was out of a can elicit nothing more. After the holiday I have then cut open (the case makes a good impression) and examined. The error was quickly found: The coil that sits on the board was only halblebig fixed with glue and was broken by the vibration of the motorcycle at the soldering point. With a new soldering and a lot of hot glue (so that nothing losrüttelt) the error was corrected electronically. The case I then glued with engine sealant again. Since then, the AC mains outlet as it should. If the interior of the can shed factory, would damage the equipment vibrations significantly less. And let's face it: with what other than water must be expected in a motorcycle besoders? Exactly. Vibrations.