Eben case lie beside pocket and a screwdriver sufficient spare O-rings, two more Luftlocheinlässe in smaller sizes and a replacement screw for the wire, if a lost. Unfortunately not at is a spare screw for adjustable positive. The turned on my adjustable positive battery support equal only times off, I but fortunately found again. Would probably also happened to me with the original. Next are two windings in, but had only 0.6 Ohm and I did not want to also use them in order to return the part possibly can.
Everything you need for commissioning is (except of course a battery carrier and Liquid) filament and cotton. Instructions for winding and inserting the wicks can be found on Youtube very good.
This is my first self-winding evaporator and take the first winding with Kanthal deposited on a Chiyou with Kick like hell, though the resistance at 2 Ohm was. (The Kick has directed it.) This part is dense and does not spit, as it sometimes happens even with good Kanger BDCs and Aspire BVCs. This is due to the construction in which liquid condensate while also occurs, but is not a problem, since the condensate is taken either by the cotton wool again or enough space for the large evaporator chamber is in the "bottom tray", from which it could be easily wiped out if it nevertheless times too much dignity. (In the small finished coils for lack of space.)
At first I was a bit skeptical given the construction - wicks that supply the winding, evaporator only fit on the base plate and is not screwed - but noted that all this is quite reasonable and very practical.