I bought this glue due to the other reviews, because I was looking for an adhesive for my 3D printer that is applied thinly, not lumpy, washable and especially without harmful gas emissions at higher temperatures. I use him as an adhesive film for printing Talman Bridge nylon on the glass plate of my K8200. the adhesive melts at a temperature of ~ 110 ° C, which is very advantageous because I print the nylon at 245 ° C and thus the adhesive surface of the nylon is soft and then again firmly. The Heizbetttemperatur I set to 85 ° C, so that the nylon is not too much to shrink all. Now I was able to perfectly print objects that are at 90% on support material, since this adhesive adhered very well. After cooling, the object can however also easily removed from the glass plate ... But be careful ... As the adhesive, as already mentioned, will melt with the Heizbetttemperatur at ~ 110 ° C, however, bed temperatures should be avoided above 100 ° C. Anyway, I'm excited by this adhesive and because I have 5 glue sticks, I'll use the other 4 or for any other bonds ... I also think that makes the glue what to ...