Installation proved to already be problematic. The Molex connector is only shaky attached to the board. When plugging the power adapter I had to be extremely careful that this does not bend at 90 ° upwards. In addition, the panel was not optimal on the chassis. In order to fix it without the slide the card out of its PCI-E slot, I would have to bend the panel slightly.
The driver installation went flawlessly, however. The card was detected this immediately, as the inserted disk. The problem described by some reviewers that the hard disk after time and again comes out, I could not find me. My hard drive was running continuously.
What did not work, a data transfer to USB was 3.0 level. Launched the card still hopeful with 140 MB / sec, the transmission rate fluctuated rapidly at 32 MB / sec and a ... so best to USB 2.0 standards. This I had, unfortunately, even after rebooting the system, notice on all available internal and external connections of the map. Even a device connected to a USB 3.0 docking station SSD was able to achieve significantly higher bandwidth requirements no.
Return causes.
