its use has also found on the NEW 3DS XL!

Hello There!
I am very pleased with the protective film, as the glue has more or less worked out the 1st attempt until now does what it should and the stylus even better slides over the bottom of the screen.

I chose because of the good recessions and double the amount for the protectors of Mumbi, so I have a second attempt in case my application at first unsuccessful ^^ '
As described, were my two protectors for the lower, and two provided for the upper screen of the 3DS XL (there is no cleaning cloth and also no plastic cards here).
I have used them for my NEW 3DS XL, as the successor supposedly has the same display dimensions and I wanted to protect my touch as soon as possible.

Upper screen:
really pinpoint fit, you should scrupulously observe the orientation! .... Which I have not done, and the film therefore had to solve 2x again.

Lower screen:
but up and down just right, the film does not exactly at the left and right edges with the screen off. A total of approx 1.5mm air, which dirt could accumulate in the gap itself. Here but I'm not sure if it is the film blank or my 3DS XL NEW, the nevertheless a little bit could probably differ from the predecessor.
The tape method of dust removal was a little friemelig, but works great. However, everyone should be clear that this only works with individual particles and not the entire film surface ~

So if the small gap at the bottom of the screen (at least in my experience with the New 3DS XL) can live and is uncertain also, whether he creates the same with the 1st attempt to install, which I can recommend the protectors highly enough =] !