This antenna is designed and thought to best optimize the reception of DTT (digital terrestrial television), antennas rakes (analog signals UHF / VHF prone to parasites) they are compatible (thus less efficient except the very large all about winning dbi).
You can install the antenna on an existing mast to replace an old rake antenna.
But if your installation is new, or if you want to remove your mast you will be able to fix it directly to a wall exposed side emitter TNT ... it will just direct it to the right or left to block it optimally.
The antenna is available as a beige or brick.
Installation can be done on a balcony, wall, window sill ... compactness offers many possibilities. Although it can capture inside in very favorable conditions it is best to position it outside. For the interior there is a black model that will be a little more magnified.
This antenna provides a gain of 7.7 DBi max. In most situations it will fill you!
I invite you to check out the full specs on the website of the brand
It comes with a manual, a bracket for wall mounted or on a mast with a specific hook also delivered. A rubber sleeve allows sealing of the connection to the antenna (covers specific screw provided for screwing to a standard coaxial cable by stripping and then the screw behind the antenna.)
If you see a black screen while watching TV (channel that leaves and comes back alone after ten seconds), then your dish is probably misguided (or a big tree agitated before).
Remember to also check behind your antenna connection by checking that the stripping of the coaxial cable has not been altered during the phase of tightening the screw for connection to the antenna)
To optimize the orientation of the antenna before attaching it once and for all here is a technical trick:
1-Connect your TV to the wall connection using a standard cable longer than normal (3 m or more), in order to temporarily weaken the arrival signal on your TV.
2-Point to the eye the antenna towards the transmitter for capturing chains
3- Make appear the chain that gets the lowest signal (nowadays all TVs have a level of DTT signal display).
4- point the antenna to narrow the weakest signal by making the strongest possible
5- install a better cable (double shielded) with a length of 1.5 m with Gold plated connectors.
So your reception TNT will be optimized to best ...
