1. Optics
The device looks super chic and makes itself at home on red clinker very nice - not as cheap as most slat boxes.
2. Installation
Since the hole for the hole was big enough, I have a 100mm (inside diameter) introduced telescopic implementing and sealed with fountain foam (is resistant to weathering), remember earlier, disconnect the motor and perform sufficiently long cable for the relay circuit - no problem. One must remember that while the need to plug the two wire ends, of course.
The mounting on the outer wall is not a problem with mediocre craft Cleverly. Measure nice, do everything just plugs in, base plate with silicone seal, screw on - done. Then connect the flap top, hood and off you go.
3. Function
Once the vent pipe and everything is off with sealing tape, the hood mounted and the circuit is tucked behind the telescopic metal cladding of the extractor hood, you can start. You hardly hear the engine from the inside. The flap opens smoothly and after sealing is all very airtight. Nothing hangs in the air flow and the kitchen smell is carried out clean. I would be sure to measure the performance of the hood is not too small. For me, a path of about 3.50m must be covered - with 100mm diameter exhaust pipe.
Definitely a good buy - is worth the money, because if one puts much emphasis on appearance and value.