Noise during the spin / Pumping

Since I last week has left my good old washing machine down, had to quickly establish a new one. For me the following key data were important: brand manufacturers (among other things because the supply of spare parts and services), at least 6kg capacity, 1400 rpm, good energy balance and ultimately favorable..

So I chose this Bauknecht appliance ...

1) Ordering and delivery: As always with Amazon everything went smoothly. Also I caught a nice shipping. The telephone appointment was prompt and the drivers were a day later at the agreed time at the door.

2) connecting the washing machine: For beginners is an illustrated and easy to understand instructions here. Also the tool to remove the transport safety and to adjust the washing machine is also included. What I always find a bit of a shame that even Bauknecht no Rohrschelle mitliefert here (to fix the connection between the drain hose and drain). Heard my opinion, simply to ...

3) Washing: So far I am very impressed with the washing performance. Already have hot / colored wash 60 °, mix wash tested 40 ° and short wash 30min. Clean and fast - what more could you want. Thanks to the 1400 rpm, the laundry is only slightly damp from the machine. For shorter programs is automatically reduced to 1000U / min what I think is a pity ...

4) Noise: Even though I have read a lot of negative about it, I was surpised also here positive. Water intake is extremely quiet, the washing process itself also - generally smooth running. Even the spin is quiet, but you can hear while eating a tinny roar.

I noticed that during the spin cycle the waste water pump is running. Now, if no water is pumped out and it still continues to vibrate the Kunsstoffrohr. Actually not so bad - the tube but is guided past the (if you stand in front of the device) right sidewall. This creates the tinny roar.

I have the lid open (WARNING! Disconnect the power cord before the imitation In any case, since the noise filter (top, right rear) will be inserted unplugging always 230V and accept it with bare cable lugs). Then I clipped a small foam pad between the plastic pipe and the side wall. The hum / drone is gone.

If you ankippt the machine somewhat, you can also turn down.

If you have similar sounds, you can easily test the times the right side wall at the bottom of the spin pumping or press it down slightly. If the noise is gone now, it is on the drain hose.

If you have questions simply write a comment ...