Therefore, a little tip if you need the full power via USB port eueren:
Buy yourself instead of the cable at the best a "voltage transformer 5V to 12V USB" and equal to an "extension cable (3 pin plug socket)"
This is together even cheaper than the USB cable here!
If you have both then you snips from the barrel connector from the USB voltage converter. Same makes her the 3-pin extension cable with the female connector.
The two cables simply with the "GND" (Black cable) and "+12 V" (red cable) 3-pin extension cable set. (It's best to solder it and then do not isolate forget!)
RND (yellow cable) need not because that would be of interest only to an air control on the part of the motherboard.
But the motherboard has indeed not have access to the fan which was connected via USB.
Important!
Pay attention that you connect the cable correctly otherwise your fan rotates in the wrong direction!
So the cable that in the inner area of the hollow plug was (12 V +) to the red wire set !!!
Important!
Be careful not to the fan at 12 volts no more than 2.5 watts eats! Otherwise, your USB port and everything else can abschmoren!
([P = U * I]; P = W; U = V; I = Ampere)
The fan must therefore at a 12 volt adapter need not more than 0.208333 amps (or 208,333mA)! (Just after Max amps or MAX A fan looking. Do not leave you on the details of traders but visited the manufacturing side of the fan)
I am not responsible for any damages that have happened because of my instructions.