This miracle stuff is the ultimate tip of a modeller and handyman (almost) has tried everything, what kind of things glued together. I'm actually met by chance on the internet on this product. Since I have never seen it, I have bought the same it (so-called. Klebzwang) and tried. I was immediately amazed at what you can do with it all. Properties: Viscosity as a thick oil or thin honey, good own course in corners and recesses, odorless, even in not gelled state easily and without residue waterproof washable with water (even with textile), after drying high-gloss surface and absolutely water-clear transparency. High adhesion, but with a corresponding force (pry) completely without residue with a screwdriver and remove. This of course assumes that the bonded materials also survive this procedure. Combines the advantages of a self-leveling casting resin with the characteristics of Very strong rubber in Final. The only previously identified by me minimal downside: After ejection from the nozzle is formed on the surface of a very thin skin. This happens after about 30 sec. If one passes the glue after the onset of skin formation, then the absolute smoothness of the surface is something lost (no transparency, only optical distortions) This must be kept in mind when the splice is to have the first-mentioned properties. Since then, every second counts and you would still get more out. Regardless you should of course always try for yourself whether an adhesive for the intended purpose or is not suitable. The time for curing depends on the layer thickness and takes approximately 5 mm before the 24 hours. Etc. For large layer thicknesses when pouring from deep dents to get better, the material in thinner layers od applying and drying each. to let harden. On the properties mentioned There is no change. Even though I neither related to Henkel or Pattex, by marriage or otherwise what am I this Kleber recommend without restrictions only warmly.