Proceeds received faster than expected. This tester is used to test 10BaseT Ethernet cable when you have a doute.Le tester verifies each wire is individually checked in the order specified by the standard. Each strand tested number is associated has a LED that lights up. In front of the ignition (or more) LED connected to the yarn tested indicates the result. If the LED lights which is in front of the LED of yarn tested is OK. If more LEDs light up at the same time there is a short circuit, if none lights is that the wire is cut, so that the LED Alume is not in front of it is a problem 'wiring inversion. The automatic mode scans the son cyclical manner without operator intervention while in manual mode the scan ahead a notch at each button press. It detects an abnormality broadly in auto mode and then you can switch to manual mode to stop on each anomaly. The auto mode is essential when using the remote module in the event of an audit of a domestic wiring between the dispatcher and a wall outlet because it is not possible to manually test (unless making a round trip between each support on the thread of audit manual button!)
In short, a practical, simple to use. My home wiring (yet installed by a pro!) No longer functioning gigabit I found and solved all my wiring anomalies in 2H with this tester to 15Euros. The price or are electricians this is a very good deal. I took the opportunity to check all my patches and cable.
Thanks to these 10Base2 adapters and RJ11 / 12 can also be used for these other wiring standards, but I did not test