Scope of supply: - A curtain rod (steel tube in stainless steel look), which is wrapped in plastic to protect it from scratches. - Two (also individually in plastic packed) tails in cone-shape. These are hollow and attached to the rod. The cones are then attached by a recessed in the cone (and therefore not visible) little screw with the supplied key is tightened on the rod. Here you have even a little leeway left and right, because you do not have to completely put on the cone in order to tighten it can. This has proven to be useful in my case, because I have set the wall fixings are too far apart. - Six screws with six matching 6 dowels (both about 3 cm long). Mir was enough to secure an anchor each bracket (previously it keeps ;-)). If you want to, but you can also hunt three dowels per rod into the wall. Inaccuracies in drilling are wonderful forgiven through the two slots in the holder. When the hammer drill reinforced concrete times does not get further: at the hardware store you can rent a hammer drill also. - Two wall mounts that can be dismantled into three parts, which are then fixed with "invisible" screws: Distance betw. End curtain rod and wall = 9 cm Distance betw. Center curtain rod and wall = about 7.7 cm Again, you can pull out the wall bracket a little further and then install the screws. The curtain rod is prevented by small plastic inserts on slides horizontally. - Metal rings with Faltenleghaken plastic
Conclusion: this high-quality curtain rod is supplied with everything you need and is flexible to 100%. She is super adaptable to the circumstances and you realize that was made to every detail thought.