Unfortunately corresponded to the result - despite strict compliance with the instructions - not quite what I expected. Before applying the Rostumwandlers the entity in question has been thoroughly sanded down to the metal and cleaned with silicone remover. Any remaining residual rust was apparently removed by the converter (indicated slightly bluish coloration of the sheet), but it was with this with the default 2 layers within an hour, followed by 24 hours of drying time is not possible to establish a proper primer layer. It formed a light brown crust, which, however, turned out very uneven and everywhere had small hairline cracks. Not just a good basis for the following paint system. I had therefore to remove this crust again and begin building a common anti-corrosion primer new.
