The holder comes in a simple cardboard box, the assembled all 4 cast aluminum parts and 2 mounting screws for the basic device contains. Plus, there's a (high quality!), Long allen-angle key that fits all existing bolts. The need, because the screws are tightened brutal. The box is labeled "only for multi-master 250", but the wired, newer 350s fits well. The castings have the typical production, rough surface, the casting seams are unprocessed. That may be criticized, or may not - use a disadvantage it is not safe. Otherwise, the holder is made solidly constructed and accurate; everything fits without clearance. In the combination of these components allows multi-master in various ways to the holder in both stationary on tabletops, as well as fix a drill. The latter goes well with a vertical arrangement of the MM, which then results in a lateral offset of the tool axis for Bohrständeraufnahme of about 70mm. I do not share some criticisms expressed herein. So I am, for example, quite happy about a hex wrench in Systainer (the space for the holder has) to have at hand. Therefore, I need no more solid packaging. The loose screws have the advantage that they are easier to carry new (eg also Torx) can replace screws after the "rounding off", and a user manual for I do not miss such a simple part also. For that I would have a finer classification (15 °) of tilt scale and a better grip of the holder and clamping screw desired. So just everyone has their preferences. Overall, I think this holder for a successful, very useful accessory that is worth the money.