I needed a cable for a special solution, the supply of a Raspberry Pi B (first version) on a längsgerelten PSU. As the Micro-USB jack is located opposite the connections for USB and Netzerkkabel, it should be one with angled connector, so not far out are on two narrow sides the cable. The cable has removed on both sides, about 5 cm from the connectors, a molded ferrite for attenuating disturbances, the plugs are an exact fit, wiggle and do not jam. Since the longitudinal regulated power supply that I use has (as we have said, technical special solution), a hollow socket, I abgescnhnitten the USB-A connector on the other side and soldered a barrel connector. Here a reasonable double screening with copper braid and shielding foil underneath came to light. The core colors of the USB cable comply with the standard. Highly Recommended!