We use the wax in our pine dining table. For 20 years we have sanded the table every 3-4 years and repainted, each time with a different paint because we were not satisfied with any. The painting of 5-6 layers went over 2-3 days and drying again 3-4 days. Six months ago, we now tried it with this wax. After grinding of old paint applying the wax was done in 20 minutes. During this time the table already had 3-4 times waxed dried and polished. After that he was ready to use. A painting has the advantage that she can take in the early days of mechanical loads and heat well and can be easily cleaned with water. However, this advantage is lost with the time when the mechanical Bela hours but left its mark in the paint and the table thus is uglier, but one accepts this for quite some time because of the expense of repainting is quite large. The wax we found that the surface is sensitive to heat, such as those emanating from a pot or a hot plate or cup. This heat dissolves the wax in part, so that the tracks are visible. Even with the wet wipe of the table will be removed over time wax. The good thing is that can solve these problems in just 1 minute by simply again nachgewachst (and polished after a few minutes drying time). All problem areas disappear completely again and you get a new-looking table. As for the very first waxing for the first time a stain could be seen from a hot plate, the wood grain this point intensive (dark) could be seen, as the rest of the table. So I thought, a heat treatment of the remaining table would adjust the color again. I took a hot air gun (a hair dryer would probably go too, but longer) and thus treated the whole table top, ie, the wax was briefly liquid. After 2 minutes, and that was done after the wax again dried and polished was was like the whole surface again expected uniformly and better than before. We now use coasters when warm objects, which prolongs the time until the next growing significantly. Approximately Regrow 1 times a week and polish, is done in 2-3 minutes, and you have again a new-looking table. The first time we used guards an old kitchen sponge, the regrowth is sufficient even a paper kitchen towel to polish an old towel or cloth towel. We have been fully satisfied with the result. I would do it again. Although the nicks in the wood times are so deep that we would grind the wood again, this is probably much faster and easier than before to go, because most of the work caused the abrasion of the paint layers. Was this only times from the smooth surface grinding was done quickly. Now it will be much easier, because the wax layer is the heat gun simply evaporates during prolonged draufhalten and you can then immediately grind the raw wood.
