As technology amorous and trained electrical engineer I have accepted a couple of torments during installation: The manual is just bad. The module will only fit very tightly into a switch box. Box terminals match the best Will no longer inside. I have only the 3 core switch line are fortunately in the can. The Teach has almost a failure of the "project" means. Nowhere I could take the train 'the instructions of the remote control (HE 844) on channel 1 (Dip switch 1 on the battery compartment) does not. Through trial and error I have found 2 channel (Dip switch 2 on - off 1). All previous devices had now just balls to be trained on channel 2. I have also found that a short about 1 sekündiges pressing enough to start the learning phase (red LED flashing). A press> for about 10 seconds, the LED can blink faster, which means I do not know. The learning process, I have ultimately appropriated by Youtube. I also own the HE853 USB interface that directly Teach allowed, this fact is due to that I have not complained about the device.
Assessment: - Poor manual.
- Relatively difficult installation due to the size.
- No feedback channel (warning device on the remote control / USB adapter)
+ There is no neutral conductor required, which does not exist in a switch box often.