Sigma K2 ceramic heater

Yes, what can I say?
Heated !!! : D
My old mat had, after all, for about 15years, considered to bless the time (in the summer you realize that just do not), but when it was cooler-well;)
Everything works wonderfully, but if you have a bed frame which is flush with the floor panels, you do not get carried out the plug. The thermostat can disconnect though, but safety plug and thermostat connector remain just on the cable and take just the place you need.
The heater is now for three days busy, the (approx) 700l back to a comfortable temperature (around the 29-30 ° C) to bring-that this takes some relatively cold, it should be clear at ~ 230W.
I am pleased once again to my warm bed :)

Note:
The only problem is that one of the heating insert into the filled (!) Bed, almost always shifts the calming mats. And that's not good.
Therefore would really pump out better.
We have indeed hammer out again, at least apparently, but if it is successful, will be shown at the next move.

* Addendum *

After nunmher 4 weeks use and using a commercially available Verbrauchsmeßgerätes, get the heating to approx 65kwh. Included in this are alone 20kwh in the first week of the heat (the old heater did not more).
Of course, this is an individual value, since it depends on several factors, but when I compare the value with the old heater that has consumed about 120kWh in (ok, winter) month, then I am satisfied. There is still enough air to the old usage, so we go just assume that it will remain at a certain Mind Ever custom / stay.