Looking for a kind of flower stairs for my plants, I found two ways at Amazon: A floral frame with glass pedestals and those same Kesper flower stand. The price was the decisive factor. The structure is simple without making tool itself. However, it should be avoided to tighten the screws in the bars with too much force / violence. In this respect, I can understand if some broke the flower stand. For this flower stand, it is not required / advisable to trim everything to wobble-free. It is enough, as far as attracting the rods that building is no play. It is positive that the feet are covered with plastic caps. Thus, in light push is on parquet also not expected to coincide with scratches the metal bars. Disadvantage is definitely that the stand when loaded (see the photo of my uploaded here) does not move to be jerky. Then you have definitely to be expected that the plant can fly down from its pedestal. Not unimportant is also to be noted that the diameter of the pedestals is not only true for the bottom side of the flower pots, but also for the upper diameter. As my bottom a smaller diameter than the top, adjust down though wonderful, but are from the second highest to the highest, middle podium to (22er diameter above 20.5 cm height of the flowerpot enough). My original plan for the preparation of my plants at the flower stand I could not perform. The highest average podium remained free (until I had put a decorative figure in there). For me it is the appropriate flower stand for my large plants, which are better presented by the flower stand, without the flower stand would be too much jostling optically in the foreground. For smaller plants, but I probably would prefer another. All in all, for the price is the stand okay.