Well the whole thing is made of plastic, but my dear Senseo also, so that's just today.
Wobbled has nothing and the plugs are firmly seated, as far as works so all the best.
Today I copied my hard drive with the operating system, without PC.
The hard disk with the operating system comes forward in the "A" slot empty hard drive back in the "B" slot.
The Windows disk has 120GB and as I said, the dock is not connected to the PC, the new hard drive 500GB.
If both plates are in there, front the big button hold for about 3 seconds and copying began.
Good to know are the front flashing LEDs when all 4 LED's are permanently on the
Copying completed.
120Gb were in about 20 minutes Copies, and the new board ran without difficulty in PC.
ALSO:
Old hard drive: 120GB
New Hard Drive: 500 GB
"ATTENTION"
I was amazed that the new hard drive had 2 partitions. The first partition was to my surprise even 120GB large as the old disk that 2.Partition must only under "Disk Management" formatted and enabled the remaining ones were you 380GB.
For me angry because I have the 120GB only Copies because the plate for C: had too little space.
Now I have to try the 120Gb and 380GB hard drive with a program to bring together.
Otherwise, everything works perfectly.
For me it was really even thought sometimes just a "loose" hard drive on the PC to connect.
So everything is OK
Addendum:
Thus, the partitions now have joined with Paragon Partition Manager 11th
Since the computer, logically, start in the DOS mode has the whole time just 1.5 hours lasted.
The bottom line has become the 1: 1 copy is not worth it because the merge has lasted as long as
if I had made the Dirket with Paragon.
Conclusion: 1: 1 copies only when both plates are the same size.
