Instead of dancing around with a chainsaw in 3m to 4m height, I was looking for the best manual saw for these purposes, because my health is better than even spend a few euros more.
I came again and again to this model and have also looked at dozens of videos and was impressed with how easily even bein thick branches were sawn off.
As the saw was then there, it went off. I've done about 150 cuts. Not softwood, but hardwood: apple tree, plum trees, quince and cherry. It was really fun to use a tool that works so well! The only strenuous was when times had to cut overhead. Had you but a good position, then go 4cm diameter branches with three movements.
Always saw on the train! The bent blade supports one doing wonderfully because something away from the cut while pushing back forward, the saw blade. As you drag, then exert pressure again.
The length of the blade:
Is to cut right to the branches! My fear was that it is too long. In practice, the length never bothered. On the contrary, because it was so long, a 20cm diameter piece could hardly be separated. Although with different angles approaches, but it has funttioniert.
Section:
The cut is perfectly smooth.
Caution To avoid tearing the bark on the tree when heavy branches to be cut (violation of the tree), something. From below through the cortex by sawing One saws now the main part of the above, you get a clean cut without "tearing wounds".
Blade:
10/30 has proven for my purposes as well. Feiner would strenuous, would coarser probably too coarse. However, I have no comparison.
The nose at the end of the saw blade turned out to be very useful. When sawing to train so you get a response when "circuit" is. So the subsequent slide is very easy, because you have not pulled the saw blade and would start again.
The blade is replaceable!
Sheath:
The sheath lets you attach it to your belt. Thus, it could be also a good climber.
Also very convenient: with a clip, you can also lose weight vagina including saw.. The other side of the clip remains on the belt. So they can be easily and other store.
The sheath also has a minor role at the opening. Leaving aside the saw in / from the / vaginal slide, then roll the teeth of the saw on the role. Otherwise they would be yes sawn broken.
It can be bad cut when the road wobbles or yields. Always hold.
After sawing, I cleaned the blade and dried. So far, no rust.
Another thing: for sawing I had bought cheap gloves (CA 3). Such Rubberized from the hardware store. This is the saw firmly in hand. No slipping.
I'm excited.