I've made with the holder in the past few weeks some tours by mountain bike, while some also neatly bumpy routes used: The bracket that can be mounted during the initial installation with a few simple steps and the supplied Allen wrench on the handlebars, sat bombproof case. Since nothing has wobbled as is everything where it should, the phone was always in the desired position. Subject position - prima I find that the cell phone can align vertically and horizontally, depending on requirements. And during the break I can phone using the bracket also great in front of me on the table position - thanks to a Aufstellhebels on the back - as practical. On days where I have become wet on the bike, remained my iPhone - despite decent amounts of water from above - dry. Keep the gaskets deliver what they promise. SR buckles the holder to insert and remove the phone to also be easy to operate - really all made to measure.
Topic fit - my iPhone 5S fits perfectly into the soft rubber holder, of course I have this, small downer, every time take off the case, which my iPhone normally intended to protect against falls. The mount itself contains also again a plastic case, this I had to take out, however, that my iPhone fits into it - it is then but directly and scratch protected in the soft rubber coating.
The camera of the iPhone is of course free and can be used any time. The cable for the headset and (contrary to the product description above) and the charging cable can be easily connected. If you only pulls the cables through the slots, then connects to the mobile phone and the latter only then inserted into the sleeve that's not tricky. Connect Power Bank and load the mobile road is thus not an issue - it works. The holes are created when you open the rubber nubs on the bottom of the bracket to the cables are inserted through two small rubber bands that you have to strip on the cable, re-sealed properly so that even with the cord attached is given the tightness.
The operation of the smartphone works through the protective sleeve without limitations very well and so far, the casing has also shown to be quite scratch resistant. Attach the phone to the bracket and fix again goes quite fast, so you can quickly remove it from the wheel during a break or at the end ride again. Theft-proof, it is the holder of course therefore not - here might be even a security lock upgrade desirable so (also completed if necessary) to the bike sometimes short can lose sight of, without having to fear either just around the phone.
From the wheel removed the bracket a little clunky is naturally in your hand than a normal case, but it makes a very impact-resistant impression the phone protects against rainwater and processing can - just like the materials - convince consistently. The instructions for operation and installation of the bracket can be found on the inside of the package. Who wants to know again later how to do that with the assembly, thus the package or at least one side of this must keep. The instruction itself consists of a half-dozen more or less stringent clearly understandable Bildchen under each one more commentary, stands as an explanatory sentence in English or French. However, you really have to either of the two languages to be powerful, the images range from basically.
Conclusion the holder of Tigra Sport can virtually nothing to be desired. It's simple and convenient to install and operate, and my iPhone is prima protected against everything which could harm the bicycle him go. If now an anti-theft device is added and the option my normal default case not to always have to lose weight, then it would be perfect. Yes, even an installation guide that I can abheften than one-pager was still an idea. Either way I have so far seen no better support and recommend these here happy to - here really (practical) is offered quality.