(See my review of 250 W Bench grinder 150x20 mm)
But because the part can nix for ....
Massive heavy as a professional device. If one has peeled him only from the preservation of fat it is advisable to grease the spindle and guides
While the spindle scrapes while still turning a little, but that is due to the strong tension spring which is to equalize the spindle play. The part must first run smoothly
The vise according to a review of M. Fed is not completely rests on the lack of washers at the fixing screws of the turntable. This makes them available in the tightened state about 2mm from the bottom. Here is even a risk that when the screws are at the table (if this is hard) the Gussflansch by tightening breaks. So here definitely before panes enclose. So one can also adjust that the gag when not tighten "stick out"
Otherwise: Super part for all DIY enthusiasts but want to buy not a professional device to> 200EUR also toys are tired