In brief: I'm starting to time with the Quad-Copter on construction and flight. It all started with a phantom (I'd leave it - you want more quickly) and build for the first time quad itself. The Hex-Y6 is already being planned and there was already a trial basis once checked whether the Multiwii Board that can also.
For Board: The software is on it, is the original Multiwii Board (not a copy from the Far East), the cable and the USB board work properly.
Unpacking, USB board to the Board Multiwii stuck (USB connector must point to Multiwii board ~ is also labeled), USB cable in, in Windows 8.1 drivers are installed correctly.
Then the software from the following link load: [...]
The EXE "MultiWiiConf.exe" from the following path: \ Multiwii21 \ MultiWiiConf \ Start application.windows32.
In the left pane select the following COM port and press "Start" in the middle left area.
Already all the information and attitude from Multiwii board are displayed on the PC.
In order for me 5 star and Amazon has delivered in 24 hours.. A Dream!
Update:
Unfortunately, I have to take back my complete Euphoric rating. As long as the board only flashing wants or wants to watch it with the Multiwii Software / Change's all good.
But you have to teach the gas paths of control and also the control ... there's the rub.
The first time I had the controller and the receiver on the board is connected and this is connected to the PC ... well it went well for about 20 seconds. Then the board was based on and started ne.
So USB cable out and back inside. Now the game within seconds.
Think about whether it is the USB port, from USB3.0 to 2.0, then from the PC to the laptop and finally changed nor Win8 on Win7.
Nix, the permanent error.
Ok, maybe a Monday device purchased. New Ordered .... This time it comes from China ... unfortunately found a week later.
3. Ordered ... because the next day.
Only USB and board connected via USB, works.
1! Connected controller and the receiver, laptop is supported, then the PC, bluescreen. USB HUB with external power supply. Bluescreen.
Approximately 10 times tried everything possible, suddenly it worked then times ... short but the readings in the MultiWii were complete nonsense. A straight line of all sensors ... no matter how wild the Board floundering.
End of the story:
It all goes back and I buy somewhere else a. Too Bad.
Perhaps more than for some info: I suspect that the original Board, but the USB adapter garbage. If this can not test as well as the next two reacted exactly the same.
