The Apple SuperDrive not fit in very well, but with a small pair of pliers, a little tape and a piece of foam rubber can fix it easily. During installation you have to watch something, because not accompanied by a guide. The SuperDrive first connect to the SATA connector and then to the side where the Borhloch missing both parts with some electrical tape to stick together (otherwise it wobbles when you plug in the USB connector), then press the plastic cover on it and tighten the bolt. In my case there was trouble with the plastic housing, the hole for the screw would not fit, so I've just snapped broken with pliers, pressed and only then bolted. The drive sits a little crooked (since only one page can be screwed), but is otherwise Bombenfest. I could not tell, unlike some other Rezessenten that the envelope pushes too hard on the drive. It vibrates nothing and DVD purr quite normal in the drive.
One must not forget also that you unlaulich receives much power for very little money here! Anyone who wants more and says that a simple SATA connector including housing may cost 70 euros or more, which should resort to another product. Who but a little time brings (about 10 minutes), and not an absolute Grobmotoriker is, which is well served here!
Of course, a stop to the housing lacks full again, but as standard drives usually have one yourself, it must be clear that any! So if you want obstruct his Apple SuperDrive, which will simply have no visor. I have the drive simply packed in cardboard my Samsung SSD and back into cut holes for the connections. Voila, from a carton is a diaphragm.