When Vent on the fixing of plates eighth to avoid unnecessary vibrations / oscillations. I have with us can do without the central mounting plate even (see pictures with the green kitchen wall). Only for keeping the power cord I want a notch in the Vent - so unpacked household scissors, carefully cut a notch and bent edges. See Pictures! Now is the cable rolled up in the exhaust stack inside and does not disturb further.
With us, the fan runs for technical reasons in recirculation mode (with the window open because of the increased humidity), the air flows to the chimney top on side vents and also slightly toward the ceiling from down.
Delivery with us was:
- Hood
- 2-piece Vent
- Mounting hardware
- 2 active carbon filter (17.5cm, approximately)
- Flexible tube
- Retaining flap of plastic = socket for hose
The five controls are: Stop, Level 1, Level 2, Level 3 and light.
Anyone looking for a good and affordable range hood, is hereby certainly well advised. Of course there are better models with lower volume, nobler processing and perhaps strömungsverbessertem Deduction or convection behavior, but then the cost also equal disproportionately more. And as can be seen on the pictures, the hood does a better job as a standalone version. It's cheap, it works, it wins!