Tops laptop stand for MacBook Pros

Now that I've been working for several months on my MacBook Pro while it just stood on the table, now needed a Notbook-Stäner because that is in the long term but uncomfortable.
In short, little rumgeschaut on Amazon and just the ordered here.

My Order criteria:
- Not too high a price
- Sleek, elegant and suitable to my Mac Design
- Reasonably massive and "high quality"

In the Amazon the photo thing looks not exactly sexy, I ordered it anyway and have to say my expectations were exceeded !!

Pros:
- Simple assembly options. Two legs stuck in the Plexi-part. Ready
- Sharp optics The aluminum fits _perfekt_ for MacBook Pro. (The same or very similar hue)
- Equipped with good rubber pads
- Makes a high quality impression
- Price fully justified (though you should be as Apple users probably very "painful resistant") order the 30.- but they are ok anyway. (Unlike almost 70.- for the rain-design stand)
- If the notebook it says the stand is very inconspicuous and discreet
- Even the packaging looks quite acceptable.

"Cons":
- As a previous speaker noted scratched the Plexi. For me, not yet (if then in the mm range). I think with proper treatment, should also be avoided
- The notebook is held only by rubber pads from sliding down, ie there is no "nose" or small "stopper" that would prevent the slide down. But also is not a problem as long as the gums are clean and not dirty.

Facts:
- The notebook is slightly tilted forward on the stand
- Height of the notebook. ZW 13.5 cm (front) and 16.5 cm (back) (good working height I find)
- Depth of the stand: 23 cm
- Width: about 25 cm

Conclusion:
Ideally Stand for MacBook Pros for the perfect matching optics. For all other notebooks but certainly also a very highly suitable stand.

Buy recommendation:
In any case!