I have attached the part, the software is installed, and already is the part to be found in the router. The connected USB printer but was only found after a cold start was performed. A simple restart was not enough. The software must be restarted every time, but it has to be selected if each time if you want to print or just once when the computer is rebooted. The printer will then appear but in the normal dialogue in the respective menu, it must then nothing will be done. I am completely satisfied, the low valuations dürfrten either originating from other operating systems such as OS or Linux, or from the time when software and firmware were still badly in need of improvement. 2014 is probably, at least on WIN, quite mature. nI would buy it again.