But this product (standard mat) is not suitable for scanning, because it is not supported by the plotters in this regard.
Due to the fact that the Notice to scan incompatibility missing in the product description of CAMAFT24 standard mat, this article gets to me the smallest possible rating. Unfortunately.
The Notes to be only only in the manual included with the device, but also mentions only in whittling.
Ie: When using the cutting mat on the display the error message:
"This mat can not be used."
Solution:
"This mat can not match the function performed
be used. Replace the mat. "
According to my research in the manual: Note
"In the mode Scan to USB", the optional
12 "× 24" (305 mm × 610 mm) mat is not used. "
If yes still:
Direct interface, and
Scan to cutting data.
Unfortunately, these options do not work either.
On page 48 of the device description (pdf file) which shall be read: "In the direct interface mode", the optional
12 "× 24" (305 mm × 610 mm) mat and scan
Mat are not used. "
On page 50 found in section 3:
"Note:
In mode Scan to cut data ", the
optional 12 "× 24" (305 mm × 610 mm) mat are not used. "
An even better tip would be (305 mm × 610 mm) mat to mention in the product description of 12 "× 24" the uses or the non opportunities.
I would have this mat, and even not purchased the product, when I knew only of the small 12x12 inch area would be to scan available.