Very handy, but the site has to be right

A small UFO with 10cm Ø arrives and is for connection of the S6 supplied charger can be used immediately. The charging station is made of Plexiglas with (here) white non-slip rubber ring as a bearing surface for the S6. Why the white charger is cheaper, knows for sure just Amazon.
,
,
The manual is a bit too simple.
Who wants to read the instructions beforehand can save this. They consists only of 2 sets: Insert the S6 on the charger and take it down when the charge is complete.
No information on the LED colors and what does it mean when the blue LED flashes on the charging station and not permanently lit when charging? I expect at least a decent manual for a device with an MSRP of just 50.-
,
,
The application is really easy.
After the central !! Replacing the S6 starts the charge. This is shown is inductive load through the continuous blue LED of the station, the S6 and the display. When charging is complete, this will be indicated by a green LED on station and S6.

Initially, I did not manage to bring it the green LED to light up. The charge was discontinued 85-96%. New laying then managed a further 1 to 2%, then blinked again, the blue LED.

It took a few days until I found out that it was at the site.

The inductive charging station I connected phone next to a DECT, also the metal surface of a kitchen appliance was right next to it.
After changing the location, the shop worked perfectly up to 100% and the green LED lights up.
,
Conclusion:
Extremely practical charging station, as the S6's pretty battery hungry. The shop will come with envelope.

Pay attention to a free beach resort with no other wireless phones or metal housing nearby.