The pluses:
- The head is designed for variously thick and therefore flexible tripods
- Overall quite material-saving construction, yet robust (at least of the head) and would therefore be good for use on the go
The weak points
- The rod with the mounting clips for the reflector is a bit unstable construct, and getting used to in the handle
- The head is indeed designed for many support rods strengths, to find the right opening each leads only through patient Try to target
- As soon as a reflector is clamped, it will be observed that here is to work properly only with a heavy tripod. For such enough in my case, but only the largest opening of the holder head. In order to use this but then that too short sized screw head just barely enough. Then, when I wanted to swing, which only worked when I complete again dissolved the screw - turned - and then zusammenbaute again. Reason: The gearing is well intentioned with thick (probably robust) provided teeth. But this need again about 4-5mm game to put them - what but not the short screw is sufficient. Everything completely disassembled again implement, assemble again.
Conclusion: When times assembled - to be OK. Just a little patience is required if you want to rebuild something.