With proper treatment - Super!

The thermometer is great, unfortunately it is in now with the food temperature even astronomical values. The solution is quite simple .... the thermometer must above where the cable into the sensor does not get wet. Once pure running water, it seeps through and you can forget about the measurements.

On the one hand may be very annoying, but as long as you know that it's not completely wash away, even justifiable.

Is wiping and good when water is running in the sensor is over.

++++++++++++++++++++++++++++++++++++++++++++
- Komische values ​​- UPDATE - 22.11.2013
++++++++++++++++++++++++++++++++++++++++++++

In comic values ​​due to moisture simply try the following (mine goes back 1a, but without guarantee!):

- Sensor at 150 degrees in the oven set for 15-20 minutes ... WARNING - plug must remain outside, ka if the plastic is heat resistant!
- Place sensor ne night in rice

Hab connect my sensor and he showed 74 degrees at Garguttemp (at Zimmertemp and lying loose) .... then the sensor in the oven, the device outside and after 15 minutes, the values ​​were again identical ....

The aim is to draw moisture from the sensor, which is purely run from the top and forms an electrical bridge.

Tip no guarantee, but give it a try ...