Many are indeed the opinion of the Bluetooth cell phone connection was an unnecessary gimmick,
but I think that's really handy to compare the statistics my batteries.
Also I did so all important data of the batteries available at a glance
has been found to be practical.
Unfortunately Handyapp can not display in Cycle mode, the individual capacity but
but this could be a software revision loosening.
For the charger can display on the screen but the.
(You can see the up to 12 discharge capacities Hinte purely Direction on the display)
I only wish the software still represented the current room temperatures
as statistical history to see whether the set charge strength was too high.
While the software shows how hot the battery is just, but if I do not ever
watch how hot it is I miss the end the Themperaturspitze the charge end.
The display is unfortunately not the best.
If you draufschaut not in absolute ideal angle one sees not even if the battery was fully charged.
I would have liked since 4 LEDs have wished you from afar
and so the same setting which battery is full and which Loading.
The Hintergrundbeleuchting and it turns off after 10 minutes iss but definitely good.
A problem that some other reviewers have noted (no wonder)
is much too tight pinch the battery that the metal clips.
Someone already wrote that he has the negative badly damaged in its batteries.
That was me, unfortunately, so ... I have expensive at 4 black Eneloop
the negative terminal of the insulation completely destroyed until I have finally done something about it.
One can use a multi-folded piece of paper between the battery and the contact with
extreme caution, of course, bend the clips slightly.
At least for me it fits now, but in no case should the bend too strong
otherwise the battery is firmly no longer correct and the back bend iss certainly a disaster.
But I do not want only negative review!
As the only known me charger it remembers the set current per slot.
So I do not always have to make adjustments but simply can insert the battery
and it loads in the current I entered last time.
Okay all this does not bother me but as we come to the real problem of the device.
It's loud, very loud.
I am fortunately in the situation that I do not ever need to load 4 batteries
but usually only one.
I've found that when you load a single battery, the fan will not start up to a current of 1400mA.
The Eneloop can be charged up to 1.0 C. (ie with 2400mAh capacity with max. 2400 mAh are loaded)
1400mA is about half and the value I use currently for the batteries also nich burdening too much.
For this to say is that at the first shop after purchasing the battery should be charged with less.
I've found that when first loaded after a long storage period with 1000mah
the battery 54 degrees hot is what is on the border with preset auto shutdown.
You can specify this Themperaturgrenze Although I would, however, invite the first rather recommend 500-700 mah
so that the battery does not overheat.
From the 2nd time load can be adjusted quiet 1000mAh because for me is the battery
only a maximum of 40 degrees Celsius at 1400mah if at all ... for the first few times but you should have one eye on it.
But when switching on the fan it's not about the room temperatures of the battery but the transformer and the discharge coil that is built into the charger.
My test have as I said give 1X 1400mAh maximum are without the start.
So for example, when two batteries 2x 700 mAh etc.
While the positive side is thus always well cooled, the charger,
as with many other chargers should at intensive setting
a fan will be supplied.
For example, I've found that my BC700 burning hot is at the bottom
if I set 4x 700mAh what the life certainly significantly shortened.
Nevertheless, it is very nerfig, even if the Ventillator always starts only briefly
adds up the 2 hours but then on a lot of noise.
My happiness is as I said I usually invite only a battery and therefore
in my 1400mAh setting no fan starts.
Incidentally, the fan is off during discharging,
and even I think so at 1x 1000 mah discharge.
I want 4 stars awarded for until nerfigen fan yet
It is certainly the best charger I had jeh.
All the ways to monitor the battery especially with mobile app
allow me the ability to make intelligent statements about the health of the battery.
Also, yes by the fan, the device being protected even when I next place no Ventillator.
My BC700 as they say burning hot during the bc2500 always remains nicely cool.
I expect by a long service life without the extra-cool I must.
Even totally discharged batteries were identified which had not recognized the BC700 than OK.
PS: You should fold out the stand down even if the initial nerft.
My 1400mAh value refers to the unfolded stand. (Better cooling)
I can read the display will also better and since I have a little bent contacts
is also strong enough to orient the batteries without the fold over.
PS2: The Handyapp will only work with a new Android mobile phone with high resolution.
My old Samsung GT-S5830i could indeed start the software but do not constitute useful.
My Samsung S4 but had no problems. Other mobile I did not.
Hope I helped you ... Good battery charging !!
If this recession has been helpful to you, please click on YES.