A resistance (measured and sampled) 2,8kOhm (Mario says 4-5,7kOhm) must be soldered from the right of the contacts between Bury 3.From left and 1st. Thus, the Bluetooth device in VW is released. So adapter connector back down screw (4 x Torx). It is a printed circuit board visible. There as I said between the connector contacts and 3VL 1VR solder a small resistance of 3kOhm and insulate against the circuit board, screwing into place, in the FSE, try, happy. Oh: Bluetooth code at VW is 0000. See Marios 4 + 5 (customers image on the product).