Cooler hui, mounting Ugh

Actually, this is a top cooler, but only when it is mounted.
I have to say Fortunately, the my Cooler Master Case
a motherboard tray has therefore carried out the entire assembly
outside the housing. Yes, this cooler fits despite the extreme
Height through the opening, including board and motherboard tray.
This cooler can even be semi passive in the housing,
So cool with case fans.

Now the BUT:
- The plastic sleeves for mounting the radiator support are the absolute idiocy

(Just an aside)
I have installed in my life already many coolers, including Nordbridge-, graphics card,
VRM and CPU cooler, a few times everything with water cooling.

But the above-mentioned plastic sleeves would calm can be a bit thicker because a proper resistance
one does not feel the tightening of the radiator bracket. I did it more by feel.

Unfortunately, the supplied installation instructions is totally confusing and not testifying.

The fixation of the bracket is very fiddly.

If the cooler is then finally assembled, this is absolutely great.

The supplied PWM fan is absolutely ok if he runs because he turns in my section betw. 400-600rpm.

Conclusion:

The cooling capacity ranges at a Core i5 4570 even for a semi passive operation.
If only the Assembly would not, but this was already criticized in the c't project.
If the assembly instruction is not so confusing and some details more about the
Mounting the radiator support would be cheap and would Plasteikhülsen slightly thicker,
I would give the radiator also 5 star.