Description of the Helmet Mount function at the AZ1 for Bike Kit and Wearable Kit
Sony HDR-AZ1 wearable mini size Action Camera Kit with professional feature (Splash-proof with Exmor R CMOS Sensor, Carl Zeiss Tessar optics strong light, image stabilization, WiFi, NFC function) white (Electronics) 5
Sony HDR-AZ1 wearable mini size Action Camera Kit with professional feature (Splash-proof with Exmor R CMOS Sensor, Carl Zeiss Tessar optics strong light, image stabilization, WiFi, NFC function) white (Electronics)
I found it very disappointing that there were no figures for Helmet Mount with adhesive pads and therefore had quite a bad feeling when ordering. I did not want to have this "Riemengefrickel" with guide clips on my helmet, but a similarly convenient solution as the Contour GPS with the Rotating Surface Mount. I am therefore even a few pictures and give short an additional description. Yes, the helmet is something heavy side (as with the Contour) and assembly is only on the right side of the helmet possible (panel of the camera). A lateral alignment of the camera via the thread screw under the camera body (coin). The vertical alignment of a locking knob on the circular rotating plate on the yellow lock plate is attached. The vertical adjustment is therefore at all times without tools possible with installed camera. The horizontal (lateral tilt) orientation via a thumbscrew that protrudes rearward and is clearly visible in the pictures. The lock fits very firmly into the mounting plate, the entire building makes a solid, high-quality impression. Why not mount on the helmet top with the corresponding angle adapter - now, this is the helmet balance probably pleasant but I personally find the appearance of such a structure similar to the Gopro "ugly".