Functionally me convinced the bracket. With its three joints can be at the table mount position around (to Montiormitte) up to a height of 19 cm (desk to the bottom edge of the monitor) any of the Monitor in a radius of about 50 cm. With another joint right on the monitor mounting plate of the monitor can be rotated often theoretically as in the circle - but in practice, of course, not when cables are attached. The force to be applied, which is necessary for a repositioning of the monitor can be set for three of the four joints and can be adapted as to support the weight of the monitor.
The structure was as already mentioned very easy and took no longer than 15 min. The construction consists of three components, namely the mounting table, the intermediate piece and the end piece, to which the monitor is attached with screws. Only the intermediate piece has a cable channel, while the cable must be fixed to the tail with black cable ties supplied. Visually this is, however, no interference because the tail is almost always hidden by the monitor itself. Only the fact that the table does not provide any attachment cable attachment and the cable thus from the intermediate piece coming loose and run visible next to the desk clamp, can be potentially seen by many as a visual impairment. I personally do not mind the bean. :)
Conclusion: A device that with its (in my view) the time of purchase premium price of 120 Euro raises high expectations - and this without hesitation fulfilled and in my case even exceeds them. I am extremely satisfied and would recommend this product without hesitation.