After a few adjustments perfectly usable

Bought from the same seller, but in the E-bay. Unfortunately there are no reviews are possible. Maybe I can help other buyers to make the docking station available.
After a few changes / adjustments on my part, fulfilled the part his job to my satisfaction. Perhaps these hints may be considered by the manufacturer in the future:
The angle of the cradle is too steep, so that the display can be on the desk badly viewed and operated via touch. I have two feet underneath glued to the Vordekante with h = 4 mm (z. B. plastic or wood). The manufacturer should change the angle of the cradle accordingly.
If the mobile phone with protective sheath to be inserted into the docking station, the flange of the solenoid connector on the bottom of the charger does not fit through the opening of my sleeve, because it at least. 3.5 mm is too wide. I have broken down the station (2 screws under the rubber strips on the bottom and 2 screws inside the flange) and filed the flange left and right with a key file to each about 2mm in width and height - precision work (!). The flange (now 22mm wide) now fits easily through the sleeve and receives charging contact to the mobile phone.
The two included adapters are too narrow for the cell phone with protective cover. I use the dock without this adapter. The U-shaped cradle I front, lined back and down with suitably cut pieces of rubber material by means of double scotch tape. (I had the remains of "Ikea 'Summera'-drawer insert, synthetic rubber, 2 mm, can be cut" Even foam rubber from the craft supplies is possible..) - Watch out! - The manufacturer should enclose an additional, even wider adapter.