Yes, the reglazing is possible with a little tact: -, That start at the top of speakers - Vigorously with heating hairdryer washer - Lift with sharp Gemueseputzmesser disc, go with knife over the full width at the wheel - Always warm with a hair dryer and go deeper with a knife, you can see how the adhesive (bonding material gummiartoges) between the disk and including befindlichem LCD Loest - Down the Home button: Caution! The "menu" and "back" touch sensors are glued with reusable adhesive tape to the disc. - The buttons are wired with ribbon cable: the "Back" button leads a thin foil cable to the "menu" button, the "menu" button then introduces slightly wider ribbon cable down to the motherboard - Carefully replace the buttons on the wheel - Disc can be removed - The remains of Bondingklebers on the LCD must be removed. A large amount is possible to "rub off" with the fingertip. The rest can with a microfibre. Grooves cloth and methylated spirits are abraded. - Adhesive tape remains on the edge, ie in the range speaker, home button and the lateral edges must be removed, also here can be used methylated spirits - The two narrow glued transparent distance maintenance / protective strip at the bottom of the LCD stay tuned! But again, look for and remove these Bondingkleberresten - Prepare adhesive film. First, remove the punched holes for camera, LED and Home button. The big punching for the LCD remains only once tuned! (In the area of the foil cable that leads to. Motherboard from the "Menu" button, I had to re-cut some of the punched-out with a small pair of scissors.) - Wax paper not detract from the film - just try to make sure everything fits. - If everything fits, the yellow wax paper and above its edge and pulled off the bottom but not in the middle (LCD area) and the adhesive film is stuck with the blue side (Folientraeger) upwards to the smartphone. Only when everything fits, then the relatively rigid blue Traegerfolie and the cutout for the LCD is withdrawn. By this method the Traegerfolie there st possible to use precisely the hauchduennen Klebebaende on the side - Pull Now from the disk both protectors - In the LCD. Area is a further, third protective film, which is also deducted - Check the position of the touch sensors. Insert disc from the bottom, touch sensors are glued back to the new album with the old tape Press wheel -
The method entails that, in contrast to the work state, the disk on the LCD region is not connected to Bondingkleber, but a hauchduenner air gap between plate and LCD consists. Here, by contact (direct contact disc - LCD), a spot formed, which is visible only when the non-operation of the LCD. Also probably could Staubkoerner between disk and LCD penetrate. Bondingkleber is not included! Possibly Additionally get for a "perfect" result, but do not know how easy or difficult it is to apply.
But it is also like that.
The fitment of disc and adhesive film is good. The "tool kit" is actually unnecessary, the plastic spatula but I could really use to remove the Bondingkleberreste.
The delivery took place as a letter from German address and was fast.