- For installation I advise you to get help and:
- 1 / Check each aluminum tube in case a small shock is present as minor for us on a tube. So you will orient the possible unwanted blow to the inside of the truck. Because it is not possible to adjust or remove the tubes once sunk a little.
- 2 / Ebardez that the tubes at both ends with sandpaper and wipe with a cloth otherwise it will be very difficult to climb even typing hard. (There you have been warned).
- 3 / Add inside some tubes silicone oil with a finger to ease the interfitting with a rubber mallet and accessories provided by the manufacturer to avoid damaging the tubes .
- 4 / For the trays, you must tap turning on the four plastic studs up cleats to avoid too extreme angle cut plastics.
- 5 / To install the wheels Use a large flat screwdriver and rubber mallet to tap the base and push.
Remember that it is impossible to rear engine driven through the tubes or even the wheels and guide rails.