When programming came first in some frustration, as I had some here after activating the programming mode with the two buttons A + B no success with the program, even though I had kept myself strictly to the instructions. The corresponding instructions are not helpful, so I asked again by the consignor (answer came just fix as the "Simple Open").
HOW IT WORKS stress-free:
BEFORE purchasing clarify whether the original remote control
- The frequency 433 Mhz has (screw if necessary and look at the Quartz, which is the very small gray "socket" on the board with print - usually 433.92 MHz)
- Does not work with so-called "rolling code" (this change every time the code for an unknown pattern) For possibly the original FB googlen
1) programming mode:
- Press buttons A and B at the same time as long as until the blue LED flashes three times quickly
Only release button B -
- A key pressed and immediately 3 x fast press button B until the blue LED flashes three times quickly again
Release both buttons
2) original code to learn key A:
- Press button A until the LED flashes and hold
- Press on the original remote control of the key to be programmed to be learned and position the originals close to "Simple Open". Here A hold still!
Once a code has been learned, the "Simple Open" flashes, then release the button.
3) Control:
To check whether a code has been learned just press button A, while the LED lights must also be as long as is pressed.
If when you press the A button will flash the LED, the programming was not successful.
Finished! And now get out to the garage :-)
Should not it be the same fold with the learning (ie, while the A button is pressed), change the position of each of the two remote controls, sometimes-around each other. Here creative positioning attempts are then asked, as not all remote controls have their antenna front.
The B key can then be programmed immediately afterwards without step 1) but just by pressing B. A.
I hope with you that's now so smooth!
Many Greetings,
Turnip