Put 1) With my previous method (old towel underneath, Wipe in window and its frame, subtract, with the dry cloth, wipe the corners, ready) I'm much faster than with the unit. This is due to the other criticisms of the window sucker.
2) The device is clunky. It does not help that you can suck sideways and upside down, if you always strikes towards the end on the walls, then turn must and a sales edge gets, you then have to rework. Consisting only of a rubber lip I move to a through, which causes less work and requires less time.
3) the product must be turned very slowly. A Gummilipe can I turn quickly, without splashing, have thus a full window deducted jiffy. This device, however you have to turn very slowly, as water may come into the air outlet (what it actually does). When that happens, the pump dirty water splashing out of the side. Both have the wallpaper was splashed with dirty water, as well as my face - was only just past the eye.
4) The stem is too short! Had it 30cm longer, then you could at double windows well through an open half each other's clean, while it is closed. Then you have to in fact worry about dripping water and can go ran with lots of water. That the device with short handle is still unwieldy and it strikes more often, I do not have so noted.
5) I do not know if I've got to get a defective part; it looks in any case terminated or anything like this: The wiper has a pivot in order to put him in a sideways angle can. To adjust the angle, there is a locking lug which is pushed into an opening. This stop dog sits so loosely that they slip out when I hold the wiper straight up and wipe. The wiper is then free to rotate.
Because he is so not usable, I'm assuming that my copy has an error, otherwise they were told more complains.
6) In the car not to use because too clunky.
7) What do you do with it when you're done with the windows? Only empty, then rinse briefly ... and then are things around forever open until everything is dry and you can repack the unit.
The concept might become significantly more if between the pad and squeegee would be a thin tube, so that you could wear yourself as a bag with a strap on the suction body, while you can lead the then much zierlicherer lip in every corner. And for the frame a narrower lip could be placed, lest the whole suction is lost on the left and right of the frame.
Conclusion:
You have often start off and new. This produces stripes on the disc, the need to reproduce in an extra step. Bottom line I need as long as with towel, wiper and puller alone with the device about three times (!). Frames can only be so-so suck it; the corners between wheel and frame anyway unsuccessful. Again must be reworked per se.
In my case, unfortunately, bought for the recycling center. What a waste.