After I now brew printer for several months, I can comment on that with that experience: First, I must point out the advantages, because after I used Canon and Epson, I am grateful that one cartridge so handy in a bay on the front of printer takes and how to replace the narrow cartridge is a breeze. In addition, the company may not check, there are excellent cheap replacement cartridges. And I, in contrast to other companies confirm that the cartridge consumption is lower. The device has an unusual appearance printer. The keys are soft but compact use and the indicator on the display can be read well. But now I can think of quite a few very negative features: The paper drawer is made of cheap plastic shaky and moving in the directions is always associated with the fear that one could break with his sausage fingers some of the delicate Asian tongues. The printer picks up the paper and a roll it does not come back, but forward back out, a small compartment at the back serves to be able to intervene in case of overfeeding. And that happens more and more frequently. Today there were several films that hooked up, how to load paper even better, I am not sure. If the paper is jammed, an error message, and then you can Reset anything. The best one pulls the plug. Then everything starts again from the beginning. And that is annoying for some time. I suspect that for the average consumer the cheapest is good enough, the technology is not mature, grossly overpriced the original cartridges. Intention. Too bad, because the Brother had the design and the price-performance ratio quite grades. And I would be quite willing to pay more for better processing.