All ok, but some compromises must be made

I had earlier wall thermostats and actuators, for heating. Earlier still had another name, of ELV. The HomeMatic version I have now started again. I now do not go to the actual possibilities once one, HomeMatic can offer, in a compound of CCU2 but layer on the normal operation of this thermostat.

The packaging was ok. The included manual is also ok. Here is also noted, without reading the manual is not possible intuitive operation (initial installation). In the setup is working exclusively with abbreviations, although the display was large enough.

To display is still to say, it will not light. The competitors may be better. Considering that it is not lit, the font is very small (week, Recalling window contact open etc). For older people, almost impossible to read.

The thermostat is comp. some built-in frame of various manufacturers. Some of them I have here. Merten, Busch Jaeger, Jung and Gira. They fit, but it is clearly noted, the color white is not equal to white. The compliant frame differ markedly in tone. It is therefore necessary to immediately notice that this thermostat does not come from the manufacturer of the cream used, if you use one of them. So either install them separately, in the supplied frame, or live with the significant difference in color.

In addition, an adapter for Danfoss is included. Without adapter it comes to Heimeier valves. At both types of valve assembly is easily possible. The sensors used seem to be very empflindlich, but only in one direction.

As An An Example:
It has a temp is 20 degrees and a humidity of 60% for example. If you touch only the device for example to change the temperature, then the fast is temperature within 2-3 seconds to about 0.8 - 1 degrees high and the humidity to 66%. that would not be so bad, the temp would go back so quickly down the TEMP and the humidity. However, both data need then to an hour, until the correct values ​​are reached again. As should be improved