I wanted in my office have a wireless router to my laptop does not always have to connect via cable to your network. In addition, should a new color printers from Epson, the true WLAN, but no normal network connection has (socket too expensive?) Be made available to all computers available. So fast times ordered the DLINK, which was also, as always, very quickly shipped from Amazon (that the new Hermes driver has not found me, it can Amazon nix) Unwrapped, quickly installed, finished, If I had imagined. War, unfortunately, nothing. The device has a fixed default IP (192.168.0.1, who'd thought it) and is configured as a DHCP server. So you have to hang it on an existing PC to change these settings. I wanted to operate it exclusively as an access point, so expand my existing network to a WLAN. This proved more difficult than expected. You have to change a lot of settings afterwards determine that the router is suddenly no longer reachable in the network. So again reset pressed and again from the beginning. The whole 5 times, with the help of Aunt Google. Hidden in the depths of the Internet I found the saving Note (I post here, in order perhaps to help others): If you turn off the internal DHCP server and want to use the router as an access point, is no longer allowed to him about the bush Connect "Internet" to the network, but must use one of the ports 1-4 LAN. For a small note in the enclosed Blätterwust would have been very helpful. Now everything works as it should.